FlexRadio Signature FLEX-6000 Series User Manual

FLEX-6000 Signature Series – Maestro User Guide
Copyright 2024 FlexRadio, Inc. All Rights Reserved. | Page 139
31.3 DIGI MODE AUDIO OFFSETS
When operating the radio in DIGU or DIGL mode a receive filter Offset control is available in the
Slice Receiver Menu. This control allows the operator to set the audio offset in Hertz of the center
of the receiver’s bandpass preset filters. When Tap Tuning a Slice Receiver with an Offset set to a
non-zero value, the Slice Receiver’s frequency will be adjusted so that the center of the receiver’s
bandpass filter will be tuned to the frequency that was Tap Tuned. The default offset for DIGU is
1500Hz and the default for DIGL is 2210 Hz.
This feature allows the operator to configure a narrow filter in DIGU or DIGL mode, and then
conveniently drop it over a signal of interest by simply double tapping on the signal.

FlexRadio Signature FLEX-6000 Series Specifications

General

Brand	FlexRadio
Model	Signature FLEX-6000 Series
Category	Transceiver
Language	English