FLEX-6000 Signature Series – Maestro User Guide
Copyright 2024 FlexRadio, Inc. All Rights Reserved. | Page 62
12.5 HOW TO CHANGE THE SIGNAL MAGNITUDE SCALE OF A PANADAPTER
The maximum and minimum amplitude displayed in each Panadapter may be adjusted. Tapping the
up or down arrows displayed along the left edge of the Panadapter increases or
decreases, respectively, in 10 dB increments, the maximum amplitude displayed. You may also
adjust the minimum amplitude by touching and dragging the vertical axis on the right side of the
panadapter. This will effectively adjust where the noise floor is positioned within the Panadapter.
The radio remembers these settings by band so that future switches to the band will restore these
settings.
The vertical scale is calibrated in dBm, showing the signal strength as measured at the antenna
terminal.
12.6 ADJUSTING THE PANADAPTER AND WATERFALL CONTROLS
Touching the Display control at the bottom of the first Panadapter opens the display controls.
When one Panadapter is active, the upper half of the control panel is populated, and the lower half
is blank. When both Panadapters are active the upper and lower halves of the control panel are
populated.
Complete details about the use of this screen are found in section 35.3.4, Panadapter Display
Menu.
To Next Page
Loading...
