To Next Page

To Previous Page

FLEX-6000 Signature Series – Maestro User Guide

Information about the Receive Filter’s width and the knob mode is shown in the Slice Flag’s

Annunciator area.

A short press of the inner knob cycles the RX filter through a series of preset filter configurations

that are determined by the selected mode. A long press of the knob toggles the knob’s function

between High/Low and Center/Width modes. See section 36.4, Slice Receiver Bandwidth Knobs

for more details.

Mode-specific RX filter presets are also available in the Slice Receiver Menu, which can be reached

by tapping the Slice Receiver’s frequency display.

11.7 RECORDING AND PLAYBACK OF SLICE RECEIVER AUDIO

Slice Receivers may be recorded, and the recording played back over the air using the Quick

Record/Playback feature of the Maestro. The controls for these functions are located in the Slice

Receiver Menu. Tap the Slice Receiver’s frequency display to raise this menu. The controls are in

the upper right corner of the menu and consist of a record button (red circle) and a play button

(green triangle):

On startup, there is no recorded audio in the playback buffer so the play button will be disabled

(greyed out). To record audio from the Slice Receiver, press the record button (red circle) once.

While recording, the record button will pulsate.

Recording will continue until the record button is pressed again or until two minutes have passed.

The recording will include any received audio while in receive mode and also any transmit audio

when the radio switches to transmit mode. Once the recording is stopped, the record button will

return to a solid red circle and the play button (green triangle) will be active.

To playback the audio, press the play button. If the play button is pressed while the radio is in

receive mode, the playback audio will be routed to the speakers and headphones. If play is pressed

while the radio is in transmit mode, the audio recording will also play through the transmitter.

To stop playing audio, press the play button a second time or wait for the recorded audio to finish

playing.

To record or play again, press the appropriate button. Only one audio recording per Slice Receiver

is saved. The audio played during transmission can originate in any Slice Receiver regardless of

whether the Slice Receiver that recorded the audio is the Slice Receiver now transmitting. For

example, you may record audio using Slice Receiver A and then playback that audio over the air

using Slice Receiver B. To do this, make Slice Receiver B the transmitter by selecting it using the red

TX selection below the letter B, or by pressing the Slice Receiver’s TX button. Press the MOX

button, PTT on the microphone, footswitch, or other PTT source, and then press the play button on

Slice Receiver A.

FlexRadio Signature FLEX-6000 Series User Manual

Questions and Answers: