FLEX-6000 Signature Series – Maestro User Guide
Copyright 2024 FlexRadio, Inc. All Rights Reserved. | Page 105
To enable diversity reception, tap the DIV button in the Slice Receiver Menu as shown below. This
will create a diversity slave Slice locked to the same frequency as the master Slice of the diversity
pair.
As seen in the image below, after diversity reception has been enabled a weak SSB signal has been
tuned on Slice A attached to ANT1, and the slaved diversity Slice on ANT2 is locked to the same
frequency.
Note: The RXA, RXB, and XVTR ports are also available for receiver inputs.
Maestro automatically sets the Slice audio faders to place the two antennas in the left and right
ears respectively. Your brain does the rest. Remember that the sound will be very different from
normal reception since you are listening in “stereo” to the same signal on two different antennas.
Adjustments made to the AF knob raise and lower both slice receivers in unison.
To Next Page
Loading...
