Name: FlexRadio Signature FLEX-6000 Series
Brand: FlexRadio
Rating: 4 (1 reviews)

To Next Page

To Previous Page

FLEX-6000 Signature Series – Maestro User Guide

When the button is dimmed and reads “AMP Standby”, the amplifier is

connected to the radio but is in standby mode. If a signal is transmitted, the

amplifier will not amplify it. Tap on the button to change the amplifier state to

“Operate”.

When the button reads “AMP Operate”, the amplifier is connected to the radio

and ready to accept and amplify an RF signal. Tap on the button to change the

amplifier state to “Standby”.

When the button is red, the amplifier is engaged and amplifies the RF signal sent

by the transceiver.

Adjust the output power of the amplifier by adjusting the FLEX-6000’s output power. Use the RF

Power control described in section 36.5, Transmitter Knobs and Buttons. The transmitter’s output

power needs to be about 30 to 40 watts to drive the Power Genius XL. The amplifier presents a

very low SWR to the transceiver, so in general, use of the FLEX-6000 ATU is not recommended.

Questions and Answers:

Need help?

Do you have a question about the FlexRadio Signature FLEX-6000 Series and is the answer not in the manual?

FlexRadio Signature FLEX-6000 Series Specifications

General