Flowserve Limitorque MX-40 - Page 6

Limitorque MX Maintenance and Spare Parts FCD LMENIM2314-00 – 07/08
iv
Figures
Figure 2.1 – Typical MX Actuator 3
Figure 2.2 – MX Nameplate 5
Figure 2.3 – Oil Fill/Plug Locations (MX-05 through -40) 7
Figure 2.4 – Oil Fill and Drain Locations (MX-85, -140, and -150) 7
Figure 4.1 – Motor (MX-05, -10, -20, and -40) 19
Figure 4.3 – Motor, Support Plate and Adapter (MX-150) 24
Figure 4.4 – Declutch (MX-05 and -10) 25
Figure 4.5 – Declutch (MX-20 and -40) 26
Figure 4.6 – Declutch (MX-85, -140, and -150) 27
Figure 4.7 – Top-Mounted Handwheel (MX-05, -10, -20, and -40) 32
Figure 4.8 – Side-Mounted Handwheel (MX-10 and -20) 35
Figure 4.9 – Side-Mounted Handwheel (MX-85, -140, and -150) 36
Figure 4.10 – Side-Mounted Handwheel with SGA (MX-40) 40
Figure 4.11 – Side-Mounted Handwheel With SGA (MX-85, -140, and -150) 41
Figure 4.12 – Type A1 Thrust Base (MX-05, -10, -20, and -40) 53
Figure 4.13 – Type A1 Thrust Base (MX-85) - F16 Flange 54
Figure 4.14 – Type A1 Thrust Base (MX-85, -140, and -150) - F25 Flange 55
Figure 4.15 – Type B1 Torque Base (MX-05, -10, -20, and -40) 57
Figure 4.16 – Type B4 Baseplate (MX-05, -10, -20, and -40) 59
Figure 4.17 – Type B4 Baseplate (MX-85, -140, and -150) 60
Figure 4.18 – Worm Shaft (MX-05, -10, -20, and -40) 63
Figure 4.19 – Drive Sleeve (MX-05 and -10) 67
Figure 4.20 – MX-20 and -40 Drive Sleeve 70
Figure 4.21 – MX-85, -140, and -150 10:1 and 13:1 ratios 71
Figure 4.22 – Handwheel Adapter (MX-05) 77
Figure 4.23 – Handwheel (MX-05) 77
Figure 4.24 – Handwheel Adapter Assembly 81
Figure 4.25 – Handwheel Worm Gear Assembly 82
Figure 4.26 – MX-20 and -40 Clutch and Ring Components 87
Figure 4.27 – MX-85, -140, and -150 Clutch and Ring Components 87
6 Spare and Replacement Parts 150
6.1 Guidelines for Recommended Spare Parts 150
6.1.1 Wear Components 150
6.1.2 Bearings, O-rings, and Seals 150
6.1.3 Critical Components 151
6.2 Recommended Spare Parts for MX Actuators 151
6.2.1 Commissioning and Startup 151
6.2.2 Short-Term Duty 151
6.2.3 Long-Term Duty 151
6.2.4 Severe Duty 152
6.3 Other Concerns 152
7 Regulatory Information 154
7.1 Declaration of Conformity 154
Swanson Flo | 800-288-7926 | www.swansonflo.com