5522A
Operators Manual
6-6
Table 6-4. Oscilloscope Commands (cont.)
Commands Description
VIDEOMARK? Returns the VIDEO mode line marker location.
ZERO_MEAS
Zeros the pressure module or sets the zero offset for capacitance measurement using
the -SC600.
ZERO_MEAS?
Returns the zero offset for the pressure module or capacitance measurement using the -
SC600.
Table 6-5. Output Commands
Command Description
CFREQ? Returns the optimum frequency value for stimulus for capacitance modes.
DBMZ Sets the impedance used for dBm outputs (ac volts).
DBMZ? Returns the impedance used for dBm outputs (ac volts).
DC_OFFSET Applies a dc offset to an ac output voltage.
DPF
Sets the displacement power factor (phase angle) between the NORMAL and AUX
terminals for ac power output only.
DPF?
Returns the displacement power factor (phase angle) between the NORMAL and AUX
terminals.
DUTY Sets the duty cycle of square wave outputs.
DUTY? Returns the duty cycle of square wave outputs.
FUNC? Returns the present output, measurement, or calibration function.
HARMONIC
Makes the frequency of one output be a harmonic (multiple) of the other output (called
the fundamental).
HARMONIC? Returns the present instrument harmonic and fundamental locations.
LCOMP Activates or deactivates inductive load compensation for ac current output.
LCOMP? Returns whether inductive load compensation for ac current output is active.
OPER Activates the Calibrator output if it is in standby.
OPER? Returns the operate/standby setting.
OUT
Sets the output of the Calibrator and establishes a new reference point for the error
mode.
OUT? Returns the output amplitudes and frequency of the Calibrator.
PHASE
Sets the phase difference between the NORMAL and AUX terminals for dual outputs.
The NORMAL terminal output is the phase reference.
PHASE? Returns the phase difference between the NORMAL and AUX terminals.
POWER? Returns the equivalent power for dc and ac power output.
RANGE? Returns the present output ranges.
RANGELCK Locks in the present range, or selects auto ranging.
RANGELCK? Returns whether or not the preset output range is locked.
To Next Page
Loading...
