Fluke 5522A - Page 193

Remote Commands
Command Summary by Function
6
6-5
Table 6-3. External Connection Command (cont.)
Command Description
RTD_TYPE? Returns the Resistance Temperature Detector (RTD) type.
TC_REF
Sets whether the internal temperature sensor or an external reference value is used for
Thermocouple (TC) outputs and measurements.
TC_REF?
Returns the source and value of the temperature being used as a reference for
thermocouple simulation and measurement.
TC_TYPE Sets the thermocouple (TC) temperature type.
TC_TYPE? Returns the thermocouple (TC) type.
TSENS_TYPE Sets temperature sensor type when output is set to a temperature with OUT command.
TSENS_TYPE? Returns the temperature sensor type.
Table 6-4. Oscilloscope Commands
Commands Description
OL_TRIP? Returns the detected state of scope overload protection.
OUT_IMP Sets the output impedance of the SCOPE BNC.
OUT_IMP? Returns the output impedance of the SCOPE BNC.
RANGE Sets the Calibrator range when in OVERLD, PULSE, or MEASZ scope modes.
SCOPE Sets the calibrator output to an oscilloscope mode.
SCOPE? Returns the present oscilloscope mode.
TDPULSE Activates or deacvitates the tunnel diode pulser drive for the –SC600 EDGE mode.
TDPULSE? Returns whether the tunnel diode pulser drive for the –SC600 EDGE mode is active.
TLIMIT Sets the time limit for –SC600 OVERLD mode to stay in operate.
TLIMIT? Returns the time limit for –SC600 OVERLD mode to stay in operate.
TLIMIT_D
Sets the power-up and reset default for the time limit for –SC600 OVERLD mode to stay
in operate.
TLIMIT_D?
Returns the power-up and reset default for the time limit for –SC600 OVERLD mode to
stay in operate.
TMWAVE Selects the waveform for MARKER mode.
TMWAVE? Returns the timemark waveform setting for MARKER mode.
TRIG Sets the frequency of the signal at the TRIG OUT BNC.
TRIG? Returns the frequency of the signal at the TRIG OUT BNC.
VAL?
Returns the last thermocouple, pressure, or, for the –SC600, impedance measurement
value.
VIDEOFMT Selects the format for VIDEO mode.
VIDEOFMT? Returns the VIDEO mode format.
VIDEOMARK Sets the VIDEO mode line marker location.