Fluke 5522A - Page 417

C-1
Appendix C
RS-232/IEEE-488 Cables and Connectors
IEEE-488 Connector
The IEEE-488 connector on the rear panel mates with an IEEE-488 standard cable. The
pin assignments of the rear-panel IEEE-488 connector are shown in Figure C-1.
IEEE-488 connection cables are available from Fluke as shown in Table C-1. See
Chapter 9, “Accessories,” for ordering information.
Table C-1. IEEE-488 Connection Cables
IEEE-488 Connection Cable Fluke Part Number
0.5 m (1.64 feet) PM2295/05
1 m (3.28 feet) PM2295/10
2 m (6.56 feet) PM2295/20
NFRD
IFC
ATN
E0I
DIO3
DIO1
SHIELD SRQ NDAC DAV DIO4 DIO2
LOGIC
GND
GND
10
GND
8
GND
6
DIO8 DIO6
GND
11
GND
9
GND
7
REN
DIO7 DIO5
123456789101112
1324 14151617181920212223
fe-01.eps
Figure C-1. IEEE-488 Connector Pinout (connection side)
Serial Connectors
The two 9-pin serial connectors on the rear panel of the 5522A Calibrator are used to
interface with a computer, or controller, and an instrument serial port. The pin
assignments of the rear-panel serial connectors are in conformance to EIA/TIA-574
standard and are shown in Figures C-2 (Host) and C-3 (UUT).