Fluke 5522A - Page 424

5522A
Operators Manual
D-4
562 (DDE:FR ) That requires a -SC600 option
563 (DDE: ) Time limit must be 1s-60s
564 (DDE: ) Can't set ref. phase now
565 (DDE: ) ZERO_MEAS reading not valid
566 (DDE: ) Can't set dampen now
567 (DDE: ) Can't turn EXGRD on now
568 (DDE: ) Slave cannot send SYNCOUT
569 (DDE: FR) That takes a -SC1100 option
570 (DDE: ) Invalid harmonic number
571 (DDE: ) Invalid harmonic amplitude
572 (DDE: ) Duplicate harmonic number
573 (DDE: ) No trig unless OPER & settled
574 (DDE: ) Max 15 harmonics in CHwave
575 (DDE: ) Square or sine flicker only
576 (DDE: ) -PQ option not installed
577 (DDE: ) Must be in PQ mode for that
578 (DDE: ) Can't set that now
579 (DDE: ) Parameter setting too big
600 (DDE:FR D) Outguard watchdog timeout
601 (DDE:FR ) Power-up RAM test failed
602 (DDE:FR ) Power-up GPIB test failed
700 (DDE: R ) Saving to NV memory failed
701 (DDE: R ) NV memory invalid
702 DDE: R ) NV invalid so default loaded
703 (DDE: R ) NV obsolete so default loaded
800 (DDE:FR ) Serial parity error %s
801 (DDE:FR ) Serial framing error %s
802 (DDE:FR ) Serial overrun error %s
803 (DDE:FR ) Serial characters dropped %s
900 (DDE:FR ) Report timeout - aborted
1000 (DDE:FR ) Sequence failed during diag
1200 (DDE:FR ) Sequence name too long
1201 (DDE:FR ) Sequence RAM table full
1202 (DDE:FR ) Sequence name table full
1300 (CME: R ) Bad syntax
1301 (CME: R ) Unknown command
1302 (CME: R ) Bad parameter count
1303 (CME: R ) Bad keyword
1304 (CME: R ) Bad parameter type
1305 (CME: R ) Bad parameter unit
1306 (EXE: R ) Bad parameter value
1307 (QYE: R ) 488.2 I/O deadlock
1308 (QYE: R ) 488.2 interrupted query
1309 (QYE: R ) 488.2 unterminated command
1310 (QYE: R ) 488.2 query after indefinite response
1311 (DDE: R ) Invalid from GPIB interface
1312 (DDE: R ) Invalid from serial interface
1313 (DDE: R ) Service only
1314 (EXE: R ) Parameter too long
1315 (CME: R ) Invalid device trigger
1316 (EXE: R ) Device trigger recursion
1317 (CME: R ) Serial buffer full