Error Messages
Error Messages
D
D-5
1318 (EXE: R ) Bad number
1319 (EXE: R ) Service command failed
1320 (CME: R ) Bad binary number
1321 (CME: R ) Bad binary block
1322 (CME: R ) Bad character
1323 (CME: R ) Bad decimal number
1324 (CME: R ) Exponent magnitude too large
1325 (CME: R ) Bad hexadecimal block
1326 (CME: R ) Bad hexadecimal number
1328 (CME: R ) Bad octal number
1329 (CME: R ) Too many characters
1330 (CME: R ) Bad string
1331 (DDE: R ) OPER not allowed while error pending
1332 (CME:FR ) Can't change UUT settings now
1500 (DDE:FRS ) Compliance voltage exceeded
1501 (DDE:FRS ) Shunt amp over or underload
1502 (DDE:FRS ) Current Amp Thermal Limit Exceeded
1503 (DDE:FRS ) Output current lim exceeded
1504 (DDE:FRS ) Input V or A limit exceeded
1505 (DDE:FRS ) VDAC counts out of range
1506 (DDE:FRS ) IDAC counts out of range
1507 (DDE:FRS ) AC scale dac counts out of range
1508 (DDE:FRS ) DC scale dac counts out of range
1509 (DDE:FRS ) Frequency dac counts out of range
1510 (DDE:FRS ) IDAC counts (DC OFFSET) out of range
1511 (DDE:FRS ) ZDAC counts out of range
1512 (DDE:FRS ) Can't read External Clock register
1513 (DDE:FRS ) External Clock too Fast
1514 (DDE:FRS ) External Clock too Slow
1515 (DDE:FR D) Can't load waveform for scope mode
1516 (DDE:FRS ) Peak or avg ampl too high
1600 (DDE:FR D) OPM transition error
1601 (DDE:FR D) TC measurement fault
1602 (DDE:FR D) Z measurement fault
65535 (DDE:FR ) Unknown error %d
To Next Page
Loading...
