Fluke 5522A - Page 68

5522A
Operators Manual
3-14
E
Actual revision numbers replace the numbers in each of the above.
Format NV (non-volatile) Memory should be used with caution. Changes are non-reversible. The
softkeys function only when the rear-panel CALIBRATION switch is set to ENABLE, except for the
softkey SETUP, which is not dependent on the CALIBRATION switch position.
All sets all calibration and setup constants to factory setting. CAL set only calibration constants
to factory settings. SETUP resets instrument setup to factory default settings (see Table 3-3).
TMP STD (temperature degree standard) refers to its-90 (1990 International Temperature
Standard) (factory default) and ipts-68 (1968 International Provisional Temperature Standard).
F
G
to S to P to Hto G1
G1
G2
gjh008.eps
Figure 3-4. SETUP Softkey Menu Displays (cont.)