Fluke 810 - Viewer Software Error Messages

810
Users Manual
B-4
Table B-1. 810 Vibration Tester Warning and Error Messages (cont.)
Display Message Description
Failed to perform self test This message shows during the self-test. The Tester is defective. Contact the Fluke Service
Center for technical support.
Data transfer not successful This message shows if the Tester cannot connect to the Viewer software. Make sure that the
connection is good between the Tester and computer.
Contact Fluke Service
Center
An error occurred in the Tester. Turn the Tester off and then on. If the message is frequent,
contact the Fluke Service Center for technical support.
Table B-2. Viewer Software Warning and Error Messages
Display Message Description
Application encountered an
error.
An error occurred in the Viewer software. Restart the Viewer software application.
Invalid file The Viewer software cannot read the file type.
Installation file format is
wrong
The upgrade file is defective or invalid.
Tester connection is lost This message shows if the connection breaks between the computer and the Tester during
data transfer. Correctly connect the USB cable.