15
No. Function
(1) „Parameter selection“ button (right)
for selecting the following parameters
Arc length correction
for correcting the arc length
Welding voltage
Welding voltage in V.
Before the start of welding, the machine automatically displays a standard value
based on the programmed parameters. During welding, the actual value is
displayed.
Arc-force dynamic
for influencing the short-circuiting dynamic at the instant of droplet transfer
- harder, more stable arc
0 neutral arc
+ soft, low-spatter arc
The relevant symbol lights up when a parameter is selected.
to change parameters in the Set-up menu
(2) „Parameter selection“ button (left)
for selecting the following parameters
Sheet thickness
*)
Sheet thickness in mm or in.
Welding current
*)
Welding current in A
Before the start of welding, the machine automatically displays a standard value
based on the programmed parameters. During welding, the actual value is
displayed.
Wirefeed speed
*)
Wirefeed speed (m/min or ipm).
The relevant symbol lights up when a parameter is selected.
*) In the MIG/MAG standard synergic welding process, if one of these parameters is
selected then the Synergic function ensures that all other parameters, including the
welding voltage parameter, are adjusted automatically.
to change parameters in the Set-up menu
(3) Right adjusting dial
for modifying the arc length correction, welding voltage and arc-force dynamic
parameters
to change parameters in the Set-up menu
(4) Left adjusting dial
for modifying the sheet thickness, welding current and wirefeed speed parameters
to change parameters in the Set-up menu
(5) „Process“ button
for selecting the process
MANUAL - MIG/MAG standard manual welding
SYNERGIC - MIG/MAG standard synergic welding
STICK - MMA welding
Synergic A
control panel
(continued)
To Next Page
Loading...
