9-68
E43 LED Monitor (Item selection) E48 (LED Monitor, Item selection)
E43 specifies the monitoring item to be displayed on the LED monitor.
Data for E43
Function
(Displays the following.)
Description
0 Speed monitor Selected by the sub item of function code E48
3 Output current Inverter output current expressed in RMS (A)
4 Output voltage Inverter output voltage expressed in RMS (V)
9 Input power Inverter's input power (kW)
10 PID command value (final) * Refer to E40 and E41.
12 PID feedback amount * Refer to E40 and E41.
13 Timer value (for timer operation) Remaining time of timer operation specified (s)
14 PID output
PID output in % as the maximum frequency
(F03) being at 100%
25 Input watt-hour
100
Input watt-hour (kWh)
* When J01 = 0 (Disable), "- - - -" appears on the LED monitor.
Specifying the speed monitor with E43 provides a choice of speed-monitoring formats
selectable with E48 (LED Monitor).
Define the speed-monitoring format on the LED monitor as listed below.
Data for E48 Display format of the sub item
0
Output frequency
(before slip compensation)
Expressed in Hz
1
Output frequency
(after slip compensation)
Expressed in Hz
2
Reference frequency Expressed in Hz
4
Load shaft speed (r/min)
Coefficient for speed indication (E50)
×
Frequency
(Hz)
5
Line speed (m/min)
Coefficient for speed indication (E50)
×
Frequency
(Hz)
6
Constant feeding rate time
(min)
Coefficient for speed indication (E50)
÷
(Frequency
(Hz)
×
Coefficient for constant feeding rate time (E39))
To Next Page
Loading...
