9.2 Details of Function Codes
9-69
Chap. 9 FUNCTION CODES
E48 LED Monitor (Speed monitor item) E43 (LED Monitor, Item selection)
Refer to the description of E43.
E50
Coefficient for Speed Indication
E39 (Coefficient for Constant Feeding Rate Time)
Refer to the description of E39.
E51 Display Coefficient for Input Watt-hour Data
E51 specifies a display coefficient (multiplication factor) for displaying the input watt-hour
data (
5_10
) in a part of maintenance information on the keypad.
Input watt-hour data = Display coefficient (E51 data) × Input watt-hour (kWh)
Setting E51 data to 0.000 clears the input watt-hour and its data to "0." Afte
watt-hour data will not be accumulated.
E52 Keypad (Menu display mode)
E52 provides a choice of three menu display modes for the keypad as listed below.
Data for E52 Menu display mode Menus to be displayed
0 Function code data editing mode Menu #1
1 Function code data check mode Menu #2
2 Full-menu mode Menus #1 through #6 *
* Menus #1 through #7 when a remote keypad is connected.
The menus available on the standard keypad are described below.
Menu
LED
monitor
shows:
Menu Main functions
#1
!f__
"Data Setting"
F to y
Selecting each of these function code groups F to y
enables its data to be displayed/changed.
#2
"rep
"Data Checking"
Displays only function codes that have been changed
from their factory defaults. You can refer to or
change those function code data.
#3
#ope
"Drive
Monitoring"
Displays the running information required for
maintenance or test running.
#4
$i_o
"I/O Checking" Displays external interface information.
#5
%che
"Maintenance
Information"
Displays maintenance information including
accumulated run time.
#6
&al
"Alarm
Information"
Displays the latest four alarm codes. You can refer to
the running information at the time when the alarm
occurred.
For details of each menu item, refer to Chapter 3 "OPERATION USING THE
KEYPAD."
To Next Page
Loading...
