4
Process alarm (2 points) (the codes “ F and G ” in the 9th digit) cannot
be specified.
Control output 2 (the codes “ A, C, and E ” in the 7th digit) cannot be
specified.
Control output 2, communication digital input (2 points), alarm (2
points), and 24V power supply (the codes “ A, C and E ” in the 7th digit,
“ F and G ” in the 9th digit, and “ A, B, and C ” in the 10th digit) cannot
be specified.
Note 1
Note 2
Note 3
<Size of front H x W>
24 × 48 mm
<Input signal>
Thermocouple °C
Thermocouple °F
RTD Pt100Ω 3-wire type °C
RTD Pt100Ω 3-wire type °F
1 to 5V DC
4 to 20mA DC
<Control output 1>
Relay contact output
SSR/SSC driving output
4 to 20mA DC output
<Control output 2>
None
Relay contact output
SSR/SSC driving output
4 to 20mA DC output
<Revision code>
<Optional specifications 1>
None
Alarm 1 point
8 ramps/soaks
Alarm 1 point + 8 ramps/soaks
Alarm 2 point
Alarm 2 point + 8 ramps/soaks
<Instruction Manual>
None 100 to 240V AC
Japanese 100 to 240V AC
English 100 to 240V AC
None 24V AC/24V DC
Japanese 24V AC/24V DC
English 24V AC/24V DC
<Optional specifications 2>
None
RS-485 Modbus interface
RS-485 Z-ASCLL interface
Retransmission + Digital input 1 point
Retransmission
Digital input 2 points
RS-485 Modbus interface + Digital input 1 point
RS-485 Z-ASCLL interface + Digital input 1 point
<Non-standard specification>
Non-standard parameter setting
3
T
R
N
S
A
B
A
C
E
Y
A
C
E
1
0
1
4
5
F
G
N
Y
V
C
A
B
0
M
N
Q
R
T
V
W
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
F
4
5
6
7
8
9
10
11
12
13
14
Note 1
Note 1
Note 1
Note 3
Note 3
Note 2
Note 2
digit
Specification Note
PXR
45678 9
10 11 12 13 14
Thermocouple specified : Thermocouple K, Measured range: 0 to 400°C,
Setting value: 0°C
Resistance bulb specified : Pt, Measured range: 0 to 150°C, Setting value:
0°C
Voltage, Current specified : Scaling: 0 to 100%, Setting value: 0%
In any case other than the description above, specify input signals and
measured range.
The input signals for the thermocouple and the resistance bulb can be
switched with the front panel keys.
The default settings of input signals, measured ranges, and setting values
are shown below.
The default settings of control action is reverse for control output 1 and direct
for control output 2.
The reverse and direct actions can be switched with keys on the face panel.
<Power supply voltage>
Model Specifications
To Next Page
Loading...
