How to display a decimal point on Fuji Electric PXR3?
To display a decimal point on your Fuji Electric Temperature Controller, ensure that the parameter of is set to "1" or "2". The absence of a decimal point means that "0" is set in the parameter of .
General| Model | PXR3 |
|---|---|
| Control Method | PID, ON/OFF |
| Communication | RS-485 (optional) |
| Number of Control Outputs | 1 or 2 |
| Input Type | Thermocouple, RTD |
| Output Type | Relay, Current |
| Display Type | LED |
| Power Supply | 100 to 240 VAC |
| Dimensions | 48 x 48 mm |
| Number of Alarms | 2 |
| Ambient Temperature | -10 to 50°C |
| Temperature Range | Varies depending on input type (e.g., -200 to 1300°C for thermocouple) |
| Alarm Output | Relay |
Parameters are classified under three blocks: first, second, and third.
Explains how to set the SV (Setting value) and parameters for the PXR.
Explains parameter functions and provides methods for setting them.
To Next Page
