Error Code
419
Problem Solving
14
018-505
O [Cause] If an error occurred during SMB authentication, the
probable causes are as follows:
z
Authentication failed because of the incorrect user name
or incorrect password.
z
The time does not match on the SMB server and the
machine. (This may occur when Windows Server 2003 is
used.)
z
When the destination computer is Macintosh, the
specified user has not been registered as a user who is
permitted to use Windows Sharing.
If an error occurred during data transfer via SMB, the
probable causes are as follows:
z
Login to the SMB server failed while transferring the
scanned image, due to the incorrect user name or
incorrect password.
z
The time does not match on the SMB server and the
machine. (This may occur when Windows Server 2003 is
used.)
z
When the destination computer is Macintosh, the
specified user has not been registered as a user who is
permitted to use Windows Sharing.
[Remedy] Take one of the following actions, and try again:
z
Check the user name and password with the network
administrator.
z
When using Windows Server 2003, make sure to match
the time set on the SMB server and the machine.
z
When the destination computer is Macintosh, specify a
user who is permitted to use Windows Sharing.
The password cannot be retrieved. If you have forgotten the
password, reset the password.
To reset the password:
1) Select [Start] > [Programs] > [Administrative Tools] >
[Active Directory Users and Computers] on the Active
Directory domain controller where the user information
is set.
2) Display the user information by selecting [Domains] >
[Users] from the left side frame of the [Active Directory
Users and Computers] window.
3) Right-click the appropriate user from the right side
frame of the [Active Directory Users and Computers]
window, then select [Reset Password].
018-506
O [Cause] An error occurred while connected to the CA
authentication server.
[Remedy] Perform the authentication operation again.
018-507
O [Cause] Failed to authenticate the user.
[Remedy] Either the user name or the passcode entered is not
correct. Enter the correct user name or passcode.
018-508
O [Cause] An error occurred while connected to the CA
authentication server.
[Remedy] Check the server status. Then, turn the power off and on
and perform the authentication operation again.
Error Code
Category
Cause and Remedy
CPFSMO
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
To Next Page
Loading...
