5 Tools
168
Tools
5
E-mail Message
Enter a comment attached to the e-mail.
Plug-in Settings
You can browse list of available Plug-ins when you use the custom authentication and set to
switch Plug-ins.
Note • This item appears only when the Extensible Customization Kit (optional) is installed.
Embedded Plug-ins
Set whether or not to use the embedded plug-ins.
Select [Enabled] or [Disabled].
List of Embedded Plug-ins
Display the embedded plug-in name and status on the list.
Other Settings
You can configure other settings related to the machine.
Fax Service
Switches between the Fax feature and the Server Fax feature.
Note • This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
• The Fax and Server Fax features cannot be enabled at the same time.
Scan to Fax
Allows you to use the Fax feature on the machine.
Scan to Fax Server
Allows you to use the Server Fax feature on the machine.
Note • This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
Offset Stacking (Right Top Tray)
Offsetting means that each set of copies is delivered to the center tray and shifted slightly
to separate it from the previous job. When a set of copies is delivered to the front of the tray,
the next set is delivered to the rear of the tray. Set the offset function for the Right Top Tray.
Select from [No Offset], [Offset per Set], and [Offset per Job]. When [Offset per Set] or
[Offset per Job] is selected, the machine slightly shifts the output position per set or per job
(print job) respectively.
Note • This feature does not appear for some models. An optional component is necessary. For more
information, contact our Customer Support Center.
Offset Stacking (Right Middle Tray)
Offsetting means that each set of copies is delivered to the lower tray and shifted slightly to
separate it from the previous job. When a set of copies is delivered to the front of the tray,
the next set is delivered to the rear of the tray. Set the offset function for the Right Middle
Tray.