16 Appendix
620
Appendix
16
7
Select [Adjust].
8
Select [Sample Printout] again.
9
Select the tray in which you loaded paper, and press the <Start> button.
The sample printout is printed.
10
Select [Close].
11
Confirm the result of sample printout.
12
Adjust the alignment again if necessary.
13
Select [Save].
14
Select [Close] until the Services Home screen is displayed.
Note • When you configure settings under [System Settings] or [Setup] and then press the <Services Home>
button, the screen directly goes back to the Services Home screen.
Z Fold Position Adjustment
1
Select [Z Fold - A4] or [Z Fold - 8.5x11"], and
then select [Change Settings].
2
Select [Sample Printout].
3
Select the tray in which you loaded paper, and
press the <Start> button.
A sample printout is printed.
4
Select [Close].
5
Check the sample printout, measuring the A and B fold position movement amounts.
6
Enter the values you measured in step 5 in [Values A & B Before Adjustment], and the value
to which to adjust in [Desired Values A & B].
To Next Page
Loading...
