5 Tools
200
Tools
5
When receiving E-mails via POP3
Enter the POP user name (on the left side of @) and incoming POP3 mail server name in the
address section (on the right side of @). You can set an alias, such as mymail@example.com.
For Example: mymail@myhost.example.com
Account name: mymail
Machine Name
Enter the machine name with up to 32 single-byte characters.
Host Name
Enter the host name with up to 32 single-byte characters.
Important • When you use SMB, enter the first 15 letters of the host name.
The host name must be up to 15 single-byte characters to identify the machine properly.
Domain Name
Enter the domain name with up to 64 single-byte characters.
Proxy Server Settings
Configure the settings for a proxy server. Configure a proxy server when inbound/outbound
access is used.
Important • Do not set this item unless you use services requiring proxy server settings.
Use Proxy Server
Select whether or not to use a proxy server.
Proxy Server Setup
Select the proxy server specification from [Same Proxy for All Protocols] or [Different Proxy
for Each Protocol].
Addresses to Bypass Proxy Server
Enter addresses not using the proxy server. You can specify the addresses by IPv4 address,
IPv6 address, and FQDN. You can use wildcards “*” for specifying the addresses.
HTTP Proxy Server Name
Enter the server name or IP address of the HTTP proxy server. Up to 255 characters are
allowed. You can specify the addresses by IPv4 address, IPv6 address, and FQDN.
HTTP Proxy Server Port Number
Set the HTTP proxy server port number from 1 to 65535.
The default value is 8080.
Important • Do not use the numbers assigned to the other ports.
HTTP Proxy Server Authentication
Select [Enabled] when authentication is required to connect to the HTTP proxy server.
HTTP Proxy Server Login Name
Enter a login name of the HTTP proxy server. Up to 31 characters are allowed.
To Next Page
Loading...
Need help?
General
