5 Tools
194
Tools
5
FTP Client
Port Status
Select [Enabled] when you use the Scan to PC service with FTP transmission.
Note • Select a communication mode to send data scanned via FTP from [Passive Mode] and [Active
Mode]. [Passive Mode] is selected by factory default. You can change the setting from CentreWare
Internet Services.
Receive E-mail
Port Status
Select [Enabled] when you receive e-mails and Internet faxes.
Send E-mail
Port Status
Select [Enabled] when you send e-mails and Internet faxes.
E-mail Notification Service
Port Status
Select [Enabled] when you use the E-mail Notification Service. The E-mail Notification
Service notifies you of the machine status or the completion of a print job, and a direct fax
job by e-mail.
Note • [Consumables Status], [Parts Status], [Paper Tray Status], [Output Tray Status], [Jam Status],
[Interlock Status], and [Fault Notice] are notified as the machine status.
• You can configure the E-mail Notification Service in CentreWare Internet Services. For more
information, refer to the help of CentreWare Internet Services.
Important • To display the online help for CentreWare Internet Services, users need to have the environment to
connect to the Internet. The communication fee shall be borne by you.
UPnP Discovery
Port Status
Select [Enabled] to use UPnP.
Port Number
Enter a port number for UPnP communication from 1 to 65535.
The default value is 80.
Important • Do not use a number that is the same as a port number of another port. However, you can use the
same port number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP,
WebDAV, and Web Services on Devices (WSD)).
WSD
Note • WSD stands for Web Services on Devices.
WSD Print - Port Status
Select [Enabled] to use WSD Print.
Set this when you search a device on a network from Windows Vista
®
, Windows 7, Windows
8, and Windows Server
®
2012.
To Next Page
Loading...
Need help?
General
