5 Tools
242
Tools
5
6
Select [Save].
Folder Selector Setup
If you set the classification by line type, the machine classifies the received documents by
line type and store them in the folders specified.
Note • You can assign folders specified to each line to the service buttons on the Services Home screen. The
number of documents in the folder is displayed on the assigned service button. Pressing the button
allows you to confirm the documents in the folder. For more information, refer to "Customizing the
Button Layout" (P.25).
1
Select [Folder Selector Setup].
2
Select the line to register, and then select
[Change Settings].
Note • The displayed items may vary depending on
the options installed.
3
Select [On].
4
Enter the folder number (three digits) where you want to store the faxes with the numeric
keypad.
5
Select [Save].
Output Destination Setup
In [Output Destination Setup], you can set the output destination for each receiving line.
Note • This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
• The displayed items may vary depending on the options installed.
Fax Received - Line 1 to 3
Specify output tray for each line.
Fax Received - SIP
Specify output tray for IP fax (SIP).
Public Folder Printed Files
Specifies output tray for public folder for polling.
Enable Output Destination Setup
When [Enabled] is selected, the output tray of the finisher becomes a fax/Internet fax
dedicated tray.
Note • When papers, such as heavyweight paper which cannot be output to the finisher tray, are used, the
machine uses the output tray even for the jobs other than the Fax/Internet Fax service.
Reduce/Enlarge Presets
You can set the magnifications displayed as [Preset %] which are displayed under [Reduce/
Enlarge] in the [Layout Adjustment] screen. You can assign any magnification to the
Reduce/Enlarge Preset buttons other than [100%] and [Auto %].
To Next Page
Loading...
Need help?
General
