Fuji Xerox ApeosPort-V C5580 Administrator's Guide

5 Tools
196
Tools
5
 Port Number
Enter a port number for WebDAV from 1 to 65535.
The default value is 80.
Important • Do not use a number that is the same as a port number of another port. However, you can use the
same port number for a port that uses HTTP (PP, Internet Services (HTTP), UPnP Discovery, SOAP,
WebDAV, and Web Services on Devices (WSD)).
 Operation Time-Out
You can enter an operation time-out period between 1 and 65535 seconds in 1 second
increments.
ThinPrint
 Port Status
You can use the machine for print in the ThinPrint
®
.print environment. The machine
decompresses and prints the compressed print data sent from the print server.
Select [Enabled] when you use ThinPrint.
 Port Number
Enter a port number for ThinPrint from 1 to 65535.
The default value is 4000.
Important • Do not use any numbers assigned to the other ports.
Note • ThinPrint is available when the communication protocol uses IPv4.
• The maximum of three connections are possible at a time.
Protocol Settings
Set the parameters required for communications. [Protocol Settings] consists of the
following categories:

Ethernet Settings

TCP/IP - Common Settings

TCP/IP - Network Settings
Note • To configure each category, select the corresponding item and then select [Change Settings].
Ethernet Settings
Configure the Ethernet settings.
 Ethernet - Rated Speed
Select the communication speed from the followings:

Auto
Select this to detect the Ethernet transmission rate automatically.

100 Mbps Full-Duplex
Select this to set 100BASE-TX (Full Duplex) as the default value.

100 Mbps Half-Duplex
Select this to set 100BASE-TX (Half Duplex) as the default value.

10 Mbps Full-Duplex
Select this to set 10BASE-T (Full Duplex) as the default value.

Fuji Xerox ApeosPort-V C5580 Specifications

General

Brand	Fuji Xerox
Model	ApeosPort-V C5580
Category	All in One Printer
Language	English