5 Tools
156
Tools
5
Initialize Hard Disk
Initializes the hard disk.
Data deleted by initialization includes supplementary fonts, ESC/P, and HP-GL/2 forms.
Note • The secure print documents and logs are not erased.
Delete All Data
This feature is designed to prevent the leakage of confidential information of a customer
when the machine is returned to Fuji Xerox. All data stored on the machine will be deleted.
Before executing this operation, make sure that the operation is absolutely necessary.
Note • It takes several minutes to several hours to delete all data. (The time taken depends on the machine
configuration or the hard disk capacity.)
Software Options
This feature is for service representative use. For more information, contact our Customer
Support Center.
Power on Self Test
Set whether or not to perform self test when the machine is turned on and started up. If any
abnormal condition such as intentional program modification is found during the program
diagnosis, the machine stops starting up and records the information in the audit log.
Note • The information may not be recorded in the audit log depending on the status of program
malfunction.
• If the machine does not start, contact our Customer Support Center.
Check Smart Card Details
When you select [Check Smart Card Details] and touch your smart card to the smart card
reader, the information of the smart card appears on the touch screen.
Note • You can register the authentication information using CentreWare Internet Services. For more
information, refer to the help of CentreWare Internet Services.
Important • To display the online help for CentreWare Internet Services, users need to have the environment to
connect to the Internet. The communication fee shall be borne by you.
Adjust Image Position
Adjusts the position of the image to print. You can adjust the position for each tray, paper
type, side 1 and side 2 of paper. This feature can be used when you want to print with trim
mark, to cut paper, or to align the position of image on sides 1 and 2 of printout.
X direction denotes the direction of paper feed and Y direction the depth dimension of
paper.
Note • Adjust the value bit by bit so that the image may not be run off the edge of paper.
Alignment Adjustment
You can adjust output image (perpendicular angle (rhombic distortion), skew, ratio, and
print position) and set the value to 20 types. Assign the type to each tray. This feature can
be used when you want to print with trim mark, to cut paper, or to align the position of
image on sides 1 and 2 of printout.
Alignment Adjustment Type Setup
You can set 20 types for each paper type.
For more information on the setting procedures, refer to "Alignment Adjustment Settings" (P.607).
Name
Set the name of type.
To Next Page
Loading...
