5 Tools
158
Tools
5
Trays 1 to 4, 6, and 7
Assign an adjustment type to each tray.
Fold Assisting Crease
Set the number of additional folding lines between the specified fold line to prevent the
output of the folded booklet from opening.
Select from [1 Crease per Side], [2 Creases per Side], [3 Creases per Side], and [No Crease].
Note • The less the number of folding lines is, the stronger the line is. The more the number of folding lines
is, the slower the booklet creation speed is.
Adjust Image Transfer
You can adjust the transfer output value when image transfer is poor.
For more formation on adjusting image transfer, refer to "Adjust Image Transfer" (P.623).
Software Upgrade
When EP system via the Internet is used, this feature is used to upgrade the software for EP
system when the version upgrade is required.
You can specify when to start the software upgrade.
Important • After the downloading is finished, the machine automatically restarts and upgrades the software.
After the machine restarts again and the Services Home screen is displayed, the software upgrade is
completed.
Note • EP system may not be available in some regions. For more information, contact our Customer
Support Center.
• To use this feature, a dedicated contract is needed in addition to a use of the EP system service. For
more information, contact our Customer Support Center.
For information on EP system, refer to "EP System" (P.711).
1
Select [Software Upgrade].
Start Upgrade
Starts a version upgrade soon.
Schedule Upgrade
Select [On] and specify the date and time to start a version upgrade.
Delete All Certificates/Initialize Settings
Deletes all certificates stored in the machine and initializes the security settings associated
with certificates. This feature is designed to use when you cannot use a certificate data in
the machine because of an abnormality of certificate file even when the certificate is set to
enabled for [SSL/TLS Settings] under [Tools] > [System Settings] > [Connectivity & Network
Setup] > [Security Settings].
Quick Setup Home
Displays Install Wizard which requires configuring the items necessary when installing the
machine.
You can configure Screen/Button Settings, IP Address Settings, and Fax Settings.
For more information on setting items, refer to "Screen/Button Settings" (P.142), "Connectivity & Network Setup" (P.191),
and "Fax Service Settings" (P.233).
To Next Page
Loading...
Need help?
General
