Fuji Xerox ApeosPort-V C5580 Administrator's Guide

5 Tools
216
Tools
5

DH Group
Set DH group. Select from [G1] and [G2].

PFS Settings
Select whether or not to enable PFS.

Destination IPv4 Address
Set the IPv4 address of the destination.
When entering an IP address, enter the address in the format "xxx.xxx.xxx.xxx", where
"xxx" is a numeric value from 0 to 255.

Destination IPv6 Address
Set the IPv6 address of the destination.
When entering an IP address, enter the address in the format
"xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a hexadecimal value.

Communicate with Non-IPsec Devices
Select whether or not to communicate with non-IPsec devices.
IEEE 802.1X Settings
 IEEE 802.1X Settings
Configure the IEEE 802.1X settings.

IEEE 802.1X
Set whether or not to use IEEE 802.1X authentication.

Authentication Method
Select from [EAP-MD5], [EAP-MS-CHAPv2], [PEAP/MS-CHAPv2], and [EAP-TLS].

Login User Name
Enter the login user name with up to 128 characters.

Login Password
Enter the login password with up to 128 characters.

Server Certificate Verification
Select whether or not to verify a server certificate when [PEAP/MS-CHAPv2] is selected in
[Authentication Method].
Certificate Revocation Retrieval Settings
Configure the settings for certificate revocation retrieval.
 Level of Certificate Verification
Select a level of certificate verification from [Low], [Medium], or [High].
Selecting [Low] does not verify the validity of certificates.
Selecting [Medium] verifies the validity of certificates. If a certificate cannot be verified
because of a network error or any other problems, the certificate is determined as valid.
Selecting [High] verifies the validity of certificates, and determines only certificates that
have not been revoked as valid.

Fuji Xerox ApeosPort-V C5580 Specifications

General

Brand	Fuji Xerox
Model	ApeosPort-V C5580
Category	All in One Printer
Language	English