Fuji Xerox ApeosPort-V C5580 Administrator's Guide

Error Code
545
Problem Solving
15
116-388
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
116-389
[Cause] The Extension System Memory (optional) is not installed.
[Remedy] Install the Extension System Memory (optional). Contact our Customer Support Center.
116-390
[Cause] An error occurred in the machine.
[Remedy] Follow the message displayed on the touch screen and initialize the memory of the
machine.
116-391
116-392
116-393
116-394
116-395
116-396
116-397
116-399
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
116-700
[Cause] Memory is insufficient for Image Extension Kit.
[Remedy] Select Standard for the image quality.
116-701
[Cause] Unable to use the 2 Sided Printing feature because of insufficient memory.
[Remedy] Set [Image Quality] to [Standard] using the print driver.
116-702
[Cause] A print job was processed using a substitute font.
[Remedy] Check the print data.
116-703
[Cause] Probable causes are as follows:
1) An error occurred during PostScript processing.
2) An error occurred because of insufficient memory.
3) An error occurred because of insufficient memory for PostScript processing.
[Remedy] For 1), check the print data.
For 2), set [Image Quality] to [Standard] using the print driver.
For 3), increase the value for [PostScript Memory].
116-704
[Cause] An error occurred when reading the data on the media.
[Remedy] Use a computer to confirm the content recorded on the media.
116-705
116-706
116-707
116-708
116-709
[Cause] An error occurred when reading data on the media.
[Remedy] Use a computer to confirm the content recorded on the media.
116-710
[Cause] The correct document size could not be judged because the receive data exceeded the
HP-GL/2 (optional) spool size.
[Remedy] Increase the size assigned to HP-GL/2 auto layout memory.
116-711
[Cause] The size and orientation of the form specified are not matched with the paper to be
printed.
[Remedy] Match the size and orientation of the paper with the form specified, and print again.
Error Code Cause and Remedy

Fuji Xerox ApeosPort-V C5580 Specifications

General

Brand	Fuji Xerox
Model	ApeosPort-V C5580
Category	All in One Printer
Language	English