EasyManuals Logo

Fuji Xerox ApeosPort-V C5580 Administrator's Guide

Fuji Xerox ApeosPort-V C5580
725 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #548 background imageLoading...
Page #548 background image
15 Problem Solving
548
Problem Solving
15
117-312
117-313
117-314
117-315
117-316
117-319
117-320
117-321
117-322
117-323
117-324
117-325
117-326
117-327
117-330
117-331
117-332
117-333
117-334
117-342
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
117-343
[Cause] Probable causes are follows.
1)When [Image Log Control] on Tools is invalid and [Enabled] is set for [Transfer Image
Log] , [Transfer Per Job Basis] is set for [Logs to Transfer].
2)When [Transfer Image Log] is invalid (the hard disk is not installed), [Log Transfer] is
set to be valid.
[Remedy] For 1), set other than [Transfer Per Job Basis] for [Log to Transfer].
For 2), install the hard disk to the machine, or set [Pause] for [Logs To Transfer].
117-347
[Cause] The life of the component which cannot be replaced is expired. The machine itself needs
to be replaced.
[Remedy] Contact our Customer Support Center.
117-348
[Cause] The unformatted SD card used in the other machine is installed.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
118-310
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
118-311
[Cause] An error occurred during software processing.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
121-310
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
Error Code Cause and Remedy

Table of Contents

Other manuals for Fuji Xerox ApeosPort-V C5580

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox ApeosPort-V C5580 and is the answer not in the manual?

Fuji Xerox ApeosPort-V C5580 Specifications

General IconGeneral
BrandFuji Xerox
ModelApeosPort-V C5580
CategoryAll in One Printer
LanguageEnglish

Related product manuals