Notes and Restrictions
675
Appendix
16
Output Color
When you select [Auto Detect] in [Output Color] for a copy job or select [Color] in [Output
Color] for a print job, the machine may consume yellow, magenta, and cyan toner cartridges
and drum cartridges even when your document is black and white.
In addition, when [Background Suppression (Color Copy)] is set to [High Speed] under
[Tools] > [System Settings] > [Common Service Settings] > [Image Quality Adjustment],
yellow, magenta, and cyan toner cartridges and drum cartridges are always used. Thus these
color toner cartridges and drum cartridges are consumed even when your document is black
and white.
Opening and Closing of the Document Cover during the Power Saver Mode
If you open the document cover during the Power Saver mode, and then start scanning a
document immediately after the machine exits the mode, the detection error of a document
size may occur. In this case, enter the document size manually. It takes a few seconds before
the machine can detect a document size automatically. This detection error will not occur if
you load a document, close the document cover, and wait for a few seconds before start
scanning a document.
Large Size UI Kit (optional)
By factory default, the date and time are displayed on the lower side of the touch screen
of the Large Size UI Kit. If you want to hide this date and time, contact our Customer
Support Center.
The display format for the date and time can be changed in the System Administration
mode.
The time is displayed by minutes and may differ from the actual time by seconds.
On the [Job Status] screen, jobs listed in [Active Jobs] or [Completed Jobs] fill the entire
screen. Therefore, the date and time are not displayed on the [Job Status] screen.
Operations during the Power Saver mode
It takes a few seconds before you can operate the system settings under [Tools] after the
machine exits the Sleep mode.
The <Power Saver> button still lights up when you perform the operations which do not
light up the touch screen such as printing command from a computer.
A message does not appear on the touch screen if you open and close the top cover of the
document feeder when the document feeder is deactivated (such as when the service to
use a scanner is not selected). However, the confirmation message appears on the touch
screen and the <Error> indicator lights up when the document feeder is activated (exits
the Power Saver mode) while the top cover is open.
The confirmation indicator does not light up if the document is loaded while the
document feeder is in the Power Saver mode (such as when the service to use a scanner
is not selected). However, the confirmation indicator lights up and the document is
detected when you load the document and then make the machine exit the Power Saver
mode.
The machine exits the Power Saver mode when you open the document cover to copy or
scan.
After the machine exits the Power Saver mode, the document feeder and scanner device
are activated after the document cover is opened while the scanner device is deactivated.
However, to make the document detected on the document glass, make sure that the
scanner device in the document glass moves to the detect position for the document size,
and then close the document cover.
To Next Page
Loading...
