3 Maintenance
70
Maintenance
3
*2 : The remaining page yield for copy/print jobs is applicable when A4 paper LEF ( ) is used. The value is an estimate and varies
depending on the conditions such as the content printed, dot coverage (area coverage), paper size, paper type, copy/print
density, output image type, and the machine operating environment.
Important • When you replace a toner cartridge, toner may spill and soil the floor. We recommend laying paper
on the floor beforehand.
• The use of toner cartridges not recommended by Fuji Xerox may degrade image quality and
performance. Use only toner cartridges recommended by Fuji Xerox.
• When the remaining amount of toner is low, the machine may stop printing and display a message.
If this occurs, replace the toner cartridge to resume copying or printing.
• Replace toner cartridges while the machine is on.
• When the machine is in the Power Saver mode, exit the Power Saver mode by pressing the <Power
Saver> button and the <Machine Status> button on the control panel before you replace the toner
cartridge.
• When replacing the toner cartridge, press the <Machine Status> button and check the current status
for the toner cartridge even when the control panel is lit.
• After the message "The Toner Cartridge needs to be replaced." appears on the touch screen, copy or
print density may be reduced slightly.
• If a partially used toner cartridge is used, a message appears and the number of pages that you can
copy or print displayed on the screen may differ considerably.
Note • Monochrome copying and printing is available even when color toners are run out. In this case, only
plain paper can be used.
1
Open the machine front toner cover.
2
Hold the lower part of the toner cartridge of
the color indicated in the message and gently
pull it out.
Note • “Y” is for yellow, “M” is for magenta, “C” is for
cyan, and “K1” and “K2” is for black.
Never use a vacuum cleaner for spilled toner and residual toner in this product, toner
cartridge or toner bottle. It may catch fire by electric sparks inside a vacuum cleaner
and cause explosion. Use a broom or a wet cloth to wipe off the spills. If you spill a large
volume of toner, contact your local Fuji Xerox representative.
Never throw a toner cartridge into an open flame. Remaining toner in the cartridge may
catch fire and cause burn injuries or explosion. If you have a used toner cartridge no
longer needed, contact your local Fuji Xerox representative for its disposal.
To Next Page
Loading...
Need help?
General
