3 Copy
94
Copy
3
îš„Off
No finishing is carried out.
îš„Fold Only
The copies are folded in half. The number of copies that can be folded is up to 5. When
the number is more than 5, the document is divided by every 5 sheet.
îš„Fold & Staple
The copies are folded in half and stapled at the center. The number of copies that can
be folded and stapled is 2 to 25.
îš„Trimming/Pressing
This option is displayed if you select [Fold Only] or [Fold & Staple] when the Squarefold
Trimmer Module (optional) is installed.
You can specify whether to trim the fore edge of a booklet, and whether to press the
booklet spine.
Refer to "[Booklet Trimming/Pressing] Screen" (P.94).
[Booklet Trimming/Pressing] Screen
When the Squarefold Trimmer Module (optional) is installed, [Trimming] and [Book
Pressing] become available if you select [Fold Only] or [Fold & Staple] on the [Booklet
Creation - Fold & Staple] screen.
Trimming is a feature that trims the fore edge of a booklet, which is opposite of the
booklet spine, in order to finish the edge neatly.
Book Pressing is a feature that presses the spine of a booklet to flatten the spine.
Important • If outputs are not stapled, or if a finished booklet is four pages or less,
paper may be jammed or wrinkled, resulting in a poor shaped spine.
1 Select any option.
îš„Trimming
z
Off
Does not trim the fore edge of booklets.
z
On
Trims the fore edge of booklets.
Trimming
Booklet Pressing
To Next Page
Loading...
Need help?
General
