Fujitsu Airstage J-II - Page 661

REMOTE CONTROLLER MASTER/SLAVE SETTING2-15-2.
1) Select the “06” in Menu 2 Settings.
Then press the [ENTER] button.
2) Select the “0: Master” or the “1: Slave” with the [+]
or [-] buttons.
: Master : Slave
3) Press the [ENTER] button. If there is no problem, return to Menu 2 items selection screen.
In the case of settings at initial booting, display “Monitor mode screen”.
If there's 0 or more than 2 “Master” units, the number will be displayed.
If “Master” is 0, press the [ENTER] button to return to the Menu 2 item selection screen.
If “Master” is more than 2, press the [ENTER] button to return to the screen of (2).
If “Master” is 0 or more than 2, press the [MENU] button to return to the Menu 2 item
selection screen.
Number of Master units
Note:
Please set only one Master remote controller.
- (07-135) -
FUNCTION SETTING FUNCTION SETTING