Getting s tarted
Connecting external devices to the USB ports
USBdevices,USB port,Externaldevices,Devices,
You can connect a wide range of external devices to the USB ports (e.g.
printer, scanner, mouse or keyboard).
USB devices are hot-pluggable. This means you can connect and disconnect
USB cables while your device is switched on.
Additional information can be found in the document ation for the USB devices.
► Connect the data cable to the external device.
► Connect the data cable to one of the USB ports on your device.
Device drivers
The external USB devices you connect to the USB ports usually require no driver of their
own, as the required software is already included in the operating system. If the device
requires separate software, please note the information in the manufacturer’s manual.
Switching on for the fi rst time: installing the software
Installing,Software,Installing,
Once the installat
ion has been started the device must not be switched
off, unless the in
stallation has been com pleted.
During installa
tion, the device may only be rebooted when you are requested to do so!
The installati
on will otherwise not b e carried out correctly and the contents
of the hard disk
must be com p letely restored.
If the device is integrated into a network, the user and server details as w ell as
the network protocol are required during the software installation.
Contact your netw ork administrator if you have any questions about these settings.
When you switch on the device for the first time, the supplied software
is installed and configured. Plan a reasonable amount of time for this,
as this p rocess must not be interrupted.
You may need th e licence number for Windows during the installation. You can find the licence
number as a label on your device (no longer applies to Windows 8 or higher).
22 Fujitsu
To Next Page
Loading...
Need help?
General