Problem solut ion s and tips
Problem solutions and tips
Refer to the safety notes in the "Safety/regulations" manual and in the "Getting
start ed", Page 15 chapter when connecting or disconnecting cables.
If a fault occurs, try to r
ectify it in accordance w ith the measures described in the following documents:
• in this chapter
• in the documentation relating to the peripheral devices
• in the Help sections fo
r the individual programs
• in the documen tation for the operating system in use.
Help if problems occur
Should you encoun
ter a problem with your computer that you cannot r eso lve yourself:
► Note the ID number
of your device. The ID number is found on the type rating
plate on the back
, the underside or the top of the casing.
► For further clarification of the problem, contact the Service Desk for your country (see the
Service Desk list or visit the Internet at "
http://suppo r t.ts.fujitsu.com/contact/servicedesk"). When
you d o this, please have ready the identity numb er and serial number of your system.
Troubleshooting
Power-on indicator remains unlit after you have
switched on your device
Cause
Troubleshooting
The mains voltage supply is faulty. ► Check whether the power cable is plugged
properly into the device an d a grounded
mains outlet.
Internal po wer supply overloaded.
► Pull the power plug of the device out of the
mains outlet.
► Wait app
rox. 3 min.
► Plug the power plug into a prope rly ground ed
mains outlet again.
► Switc
h the device on.
30 Fujitsu
To Next Page
Loading...
Need help?
General