System expan sio ns
It may be necessary to modify the entry for the drive in the BIOS Setup.
Installing and removing a 2½ inch drive (screw fastened)
Installing a drive
► Remove the casing c over (see chapter " Removing the casing cover", P age 36).
► Fold out the drive cage (see chapter "
Opening the drive cage", Pa ge 4 7).
2
1
► Slide the drive into the ba y (1).
► Secure the d
rive with the screws (2).
► Connect the cables at the drive and at the mainboard. Make sure the polarity is correct.
► Fold the dr
ive cage into the closed position again (see chapter "
Closing the drive ca ge", Page 48).
► Fit the casing cover onto the casing again (see chapter "
Reat taching the casing cover.", Pa ge 37).
If necessary, you must adjust the entry for the drive accordingly in the BIOS Setup.
Fujitsu 55
To Next Page
Loading...
