System expan sio ns
Replacing the lithium battery
In order to permanently save the system information, a lithium battery is installed to provide
the CMOS-memory with a current. A corresponding error message notifies the user when the
charge is too low or the ba ttery is empty. The lithium battery must then be replaced.
Incorrect replacement of the lithium batt ery may lead to a risk of explosion!
The lithium battery may be re placed only with an identical battery or with
a type recommended by the manufacturer.
Do not dispose of lithium batteries with household waste. They mu st be disposed
of in accordance with local regulat ions concerning special waste.
Make sure that you observe the c orrect polarity when replacing the lithium
battery. The plus pole must be on the top!
Lithiumbattery,Replacing,Replacing,Re placing,lithiumbatteryBattery
The lithium battery holder exists in different designs that function in the same way.
1
2
3
1
2
3
► Press the catch in the direction of the arrow (1).
The battery jumps out of the holder slightly.
► Remove the battery (2).
► Push the new lithium battery of the identical type into the holder (3) and
press it down until it engages.
Fujitsu 75
To Next Page
Loading...
Need help?
General