Fujitsu ESPRIMO D5 Series - Installing a board; Removing boards

System expansions
Installing and removing an M.2 m
odule
Installing an M.2 mo dule
► Remove the casing cover (see chapter "Removing the casin g cover", Page 36).
► Fold out the drive cage (see chapter "
Opening the drive cage", Page 47).
a
b
b
2
1
► Insert the M.2 m
odule (b) at a slight angle in the direction of the arrow
(1) into the slo
t (a) on the mainboard.
► Secure the M.2 module on the mainboard with the screw (2).
► Fold the drive
cage into the closed position again (see chapter "
Closing the drive cage", Page 4 8).
► Fit the casing cover onto the casing again (see chapter "
Reat taching the casing cover.", Pag e 37).
If necessary, you must adjust the entry for the M.2 module accordingly in the BIOS Setup.
60 Fujitsu