Accessing and Completing the Setup Wizard Initial Configuration
82 U41842-J-Z125-1-76
2. Wait 15 minutes for the system to boot before continuing with the procedure.
Figure 56: Power Buttons
3. Using an Ethernet cable, connect the Ethernet port on the service laptop to an Ethernet
port on the back of the RX300 S5 server (see figure 57).
Figure 57: Ethernet port on the rear of the CS800 server
Power button
DX80 module:
Power button
RX300 S5 server:
CS800 NAS Basic
Ehernet port
The Ethernet port on
CS800 NAS Performance
is located in the same place.
To Next Page
Loading...
