Initial Configuration Accessing and Completing the Setup Wizard
U41842-J-Z125-1-76 89
Dokuschablonen qua19x24 Version 1.1us für FrameMaker V7.x vom 25.03.2010 © cognitas GmbH 2001-2010
1. April 2010 Stand 11:05.10 Pfad: G:\allgemein\CS800\1000500_FTS-Doku\1000502_GettingStartedGuide\GettingStarted.k08
13. On the IP page:
Your network administrator will provide you with the IP address information.
V
Make sure you enter the correct IP address information and that you write this
information down. If you enter the incorrect IP address information and reboot,
you will not be able to access the system.
a) Under System, enter the IP Address, the Netmask, and the Default Gateway you
want to use to join the ETERNUS CS800 to your network.
b) If your site uses DNS, under DNS, enter the Primary, Secondary, and Tertiary
DNS IP Address.
14. Click Next.
The Network Configuration - Confirm page displays (see figure 64)
.
Figure 64: Network Configuration - Confirm
15. Check your settings and click Apply if they are correct.
A WARNING indicates that changing the network configuration requires a system
reboot after the final step, see figure 65.
To Next Page
Loading...
