Fujitsu ETERNUS DX100 S3 - Setup SNMP Agent MIB Access View

Chapter 1 System Management
1.8 Network Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
115
7 Click the [OK] button.
 Setting of the SNMP Manager starts.
8 Click the [Done] button to return to the [Network] screen.
End of procedure
1.8.5 Setup SNMP Agent MIB Access View
This function sets up the SNMP Agent MIB View.
MIB View is used for defining the accessible area in the Management Information Base (MIB) database, with
a tree type structure. Use this item when defining the accessible area in the MIB database.
Up to ten MIB Views, including the default view, can be created for each ETERNUS DX.
There are three types of default views: "ViewALL", "View-mib2", and "View-exmib".
For details on the parameters for this function, refer to "A.1.7.5 Setup SNMP Agent MIB Access View" (page
712).
For the factory default settings for this function, refer to "Appendix B Setup SNMP Agent MIB Access View"
(page 981).
The procedure to change the SNMP Agent MIB view is as follows:
Procedure
1 Click [Setup SNMP MIB View] in [Action].
• If the "SNMP Function" is disabled, the [Setup SNMP Manager] function cannot be used.
• The view name that is used in the settings in "1.8.6 Setup SNMP Agent User" (page 117)
or "1.8.6 Setup
SNMP Agent User" (page 117) cannot be changed or deleted. However, note that the MIB View (Subtree)
can be changed.
• The default view can be changed or deleted.