Fujitsu ETERNUS DX100 S3 - Modify Fc;Fcoe Host

Chapter 4 Connectivity Management
4.2 Host Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
423
2 Click the [OK] button.
 Deletion of the SAS host starts.
3 Click the [Done] button to return to the [SAS Host] screen.
End of procedure
4.2.15 Modify FC/FCoE Host
This function changes the FC/FCoE host information.
For details on the parameters for this function, refer to "A.4.2.10 Modify FC/FCoE Host" (page 834)
.
The procedure to change the FC host information is as follows:
Procedure
1 Select the FC host to change the host information for, and click [Modify FC/FCoE Host] in
[Action].
• When no FC/FCoE hosts are registered, the [Modify FC/FCoE Host] function cannot be used.
• When changing the WWN of an FC/FCoE host that is currently being used, make sure to stop access to that
FC/FCoE host.
• This function can change the following FC/FCoE host information; "Name" and "WWN". When the FC host
is not registered in a host group, the "Host Response" setting can also be changed.
• When the FC host is registered in a host group, use the [Modify Host Group] function to change the host
response. Refer to "4.2.6 Modify Host Group (FC/FCoE)" (page 386)
for details.
• Both "FC host" and "FCoE host" are abbreviated as "FC host" in this section.