Fujitsu ETERNUS DX100 S3 - Start;Stop Performance Monitoring

Chapter 1 System Management
1.5 Utility Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
69
4 Click the [Cancel] button to return to the [Utility] screen.
End of procedure
1.5.4 Start/Stop Performance Monitoring
This function acquires performance information and displays the result.
The Start/Stop Performance Monitoring function is used to start or stop acquiring the ETERNUS DX
performance information. Acquired information can be checked using the [Performance] function.
For details on the parameters for this function, refer to "A.1.4.2 Start/Stop Performance Monitoring" (page
691).
For the factory default settings for this function, refer to "Appendix B Start/Stop Performance Monitoring"
(page 975).
The procedure to start or stop performance monitoring is as follows:
■ Starting performance monitoring
The [Start] button is displayed when the "Monitoring State" is "Stopped".
Procedure
1 Click [Start/Stop Perfmon] in [Action].
When exporting of the configuration information has been completed, save the log immediately.
• When the ETERNUS DX is rebooted, the performance monitoring process is stopped.
• If performance monitoring is started from other monitoring software, ETERNUS Web GUI cannot stop the
process.
• If performance monitoring is started from ETERNUS Web GUI, the process can be stopped from other
monitoring software.
If performance monitoring is started from ETERNUS CLI, ETERNUS Web GUI can stop the process. If
performance monitoring is started from ETERNUS Web GUI, ETERNUS CLI can stop the process.