Fujitsu ETERNUS DX100 S3 - Delete Snapshot

Chapter 3 Volume Management
3.19 Snapshot Management for NAS Volumes
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
332
3.19.2 Delete Snapshot
This function deletes the Snapshot configuration information.
This function is displayed in a Unified Storage environment.
The following Snapshot configuration information is deleted:
• Snapshot (SnapOPC+ sessions for all the generations)
• Snapshot acquisition schedule (number of generations, day of the week, and time)
• Snapshot destination SDVs for all the generations
Requirements for Deleting Snapshot Configuration Information
• No copy sessions other than Snapshots are set in the Snapshot destination SDVs
The procedure to delete Snapshot configuration information is as follows:
Procedure
1 Select which NAS user volumes to delete Snapshot for and click [Delete Snapshot] in
[Action].
 A confirmation screen appears.
2 Click the [OK] button.
 The Snapshot deletion starts.
3 Click the [Done] button to return to the [Snapshot] screen.
End of procedure
• This function is available only when the Snapshot status is "Active" or "Inactive" for the selected NAS user
volume. Refer to "Snapshot" in "ETERNUS Web GUI User’s Guide (Operation)" for details about Snapshot
status.
• When acquiring the Snapshot again after executing this function, register the Snapshot configuration
information. Refer to "3.19.1 Set Snapshot" (page 327)
for details.
If the controller firmware version is V10L33 or later, only one NAS user volume can be selected.
Multiple NAS user volumes cannot be selected.