Fujitsu ETERNUS DX100 S3 - Start Snapopc

Chapter 7 Advanced Copy Management
7.1 Start SnapOPC+
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
592
7.1 Start SnapOPC+
This function is used to select the copy source volume and copy destination volume, and start a new SnapOPC+
copy session.
The maximum number of sessions and the maximum number of generations for each model
*1: The maximum number of generations for a SnapOPC+ from a single copy source volume.
The procedure to start the SnapOPC+ session is as follows:
Procedure
1 Click [Start SnapOPC+] in [Action].
Model The maximum number of sessions
(per storage system)
The maximum number of generations
(*1)
ETERNUS DX60 S3
1024
512
ETERNUS DX100 S3
ETERNUS DX200 S3 2048
ETERNUS DX500 S3/DX600 S3 8192
ETERNUS DX8700 S3/DX8900 S3 32768
ETERNUS DX200F 2048
• Registering the license for the Advanced Copy function is required to start a SnapOPC+ session.
• Only SnapOPC+ copy sessions that are performed in units of volumes can be created using ETERNUS Web
GUI.
To create EC, OPC, QuickOPC, SnapOPC, SnapOPC+ sessions using range selection, and REC sessions, use
copy management software.
• When using SnapOPC+, make sure to create SDVs and SDPVs. For generation management, create SDVs
for each generation. Refer to "3.1 Create Volume" (page 253)
for details.
• An ODX Buffer volume cannot be specified as a copy source.