Fujitsu ETERNUS DX100 S3 - Backup Configuration

Chapter 1 System Management
1.5 Utility Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
66
2 Click the [Restart] button.
 A confirmation screen appears.
3 Click the [OK] button.
 The ETERNUS DX shuts down after 30 seconds. After shutdown, the ETERNUS DX restarts.
End of procedure
1.5.2 Backup Configuration
This function backs up the configuration definition data to the Bootup and Utility Device (BUD) in the CM. Up
to four generations of configuration definition data can be stored.
For details on the parameters for this function, refer to "A.1.4.1 Backup Configuration" (page 690)
.
For the factory default settings for this function, refer to "Appendix B Backup Configuration" (page 975)
.
The procedure to backup configuration definition file is as follows:
Procedure
1 Click [Backup Configuration] in [Action].
This function cannot be used under the following conditions:
• When no configuration definition data file is selected
• When no data exists in the configuration definition data file
• When an error exists with the configuration definition data file size
• When an error exists in the configuration definition data file