Fujitsu ETERNUS DX100 S3 - Modify SAS Host

Chapter 4 Connectivity Management
4.2 Host Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
427
5 Click the [Done] button to return to the [iSCSI Host] screen.
End of procedure
4.2.17 Modify SAS Host
This function changes the SAS host information.
For details on the parameters for this function, refer to "A.4.2.12 Modify SAS Host" (page 838)
.
The procedure to change the SAS host information is as follows:
Procedure
1 Select the SAS host to change the host information for, and click [Modify SAS Host] in
[Action].
2 Input new host information.
• When no SAS hosts are registered, the [Modify SAS Host] function cannot be used.
• When changing the SAS address of a SAS host that is currently being used, make sure to stop access to
that SAS host.
• This function can change the following SAS host information; "Name" and "SAS Address". When the SAS
host is not registered in a host group, the "Host Response" setting can also be changed.
• When the SAS host is registered in a host group, use the [Modify Host Group] function to change the host
response. Refer to "4.2.8 Modify Host Group (SAS)" (page 399)
for details.