Fujitsu ETERNUS DX100 S3 - Network Management; Setup Network Environment

Chapter 1 System Management
1.8 Network Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
97
1.8 Network Management
This section describes the network environment settings.
The following functions are available for the network environment settings:
• Setup Network Environment
• Setup Firewall
• Setup SNMP Agent Basic Interface
• Setup SNMP Manager
• Setup SNMP Agent MIB Access View
• Setup SNMP Agent User
• Setup SNMP Agent Community
• Setup SNMP Agent Trap
• Download MIB File
• Send SNMP Trap Test
• Display SMTP Log
• Setup E-Mail Notification
• Setup Syslog
• Setup SSH Server Key
• Create Self-signed SSL Certificate
• Create Key/CSR
• Register SSL Certificate
1.8.1 Setup Network Environment
This function sets up an the environment for the ETERNUS DX to communicate with an external network.
Configuration is required for each MNT, RMT and FST port.
• MNT port
The MNT port is used for general communication between the ETERNUS DX and the external hosts.
• RMT port
The RMT port is used when the line must be separated from the MNT port.
For the ETERNUS DX60 S3/DX100 S3/DX200 S3 and the ETERNUS DX200F, this port is also used for
maintenance of the ETERNUS DX.
• FST port
The FST port is used for maintaining the ETERNUS DX.
For the ETERNUS DX500 S3/DX600 S3 and the ETERNUS DX8700 S3/DX8900 S3, this port must be
configured.