Fujitsu ETERNUS DX100 S3 - Modify Iscsi Host

Chapter 4 Connectivity Management
4.2 Host Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
425
5 Click the [Done] button to return to the [FC/FCoE Host] screen.
End of procedure
4.2.16 Modify iSCSI Host
This function changes the iSCSI host information.
For details on the parameters for this function, refer to "A.4.2.11 Modify iSCSI Host" (page 835)
.
The procedure to change the iSCSI information is as follows:
Procedure
1 Select the iSCSI host to change the host information for, and click [Modify iSCSI Host] in
[Action].
2 Input new iSCSI host information.
• When no iSCSI hosts are registered, the [Modify iSCSI Host] function cannot be used.
• When changing the information of an iSCSI host that is currently being used, make sure to stop access to
that iSCSI host.
• This function can change the following iSCSI host information; "Name", "iSCSI Name", "IP Version", "IP
Address", "Alias Name", "CHAP User ID", and "CHAP Password". When the iSCSI host is not registered in a
host group, the "Host Response" setting can also be changed.
• When the iSCSI host is registered in a host group, use the [Modify Host Group] function to change the
host response. Refer to "4.2.7 Modify Host Group (iSCSI)" (page 391)
for details.